Home › Power Source / Network › 1GR-FE (BATTERY / CHARGING) › GENERATOR (for 100 A Type)
RM2660E _57 Power Source / Network _052832 1GR-FE BATTERY / CHARGING _0255520 GENERATOR(for 100 A Type) A

1GR-FE BATTERY / CHARGING  GENERATOR(for 100 A Type)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53806 4.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

Hide 53805 5.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

Hide 51405A 6.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Hide 53783 8.REMOVE FRONT FENDER APRON TRIM PACKING B

Hide 27020 9.REMOVE GENERATOR ASSEMBLY

a.
A267518

Disconnect the generator connector.


b.

Open the terminal cap.


c.

Remove the nut and disconnect the generator wire from terminal B.


d.

Remove the bolt and disconnect the wire harness clamp bracket.


e.
A267519

Remove the bolt and disconnect the generator bracket.


f.
A222883

Remove the 2 bolts and generator.


g.
A222885

Remove the bolt and generator bracket.