1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
11259
3.REMOVE V-BANK COVER
53806
4.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
53805
5.REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
51405A
6.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
16361A
7.REMOVE FAN AND GENERATOR V BELT
53783
8.REMOVE FRONT FENDER APRON TRIM PACKING B
27020
9.REMOVE GENERATOR ASSEMBLY
Disconnect the generator connector.
Open the terminal cap.
Remove the nut and disconnect the generator wire from terminal B.
Remove the bolt and disconnect the wire harness clamp bracket.
Remove the bolt and disconnect the generator bracket.
Remove the 2 bolts and generator.
Remove the bolt and generator bracket.