The door control receiver receives signals from the transmitter and sends these signals to the main body ECU. This DTC is stored when the applicable RDA signal cannot be received within 1 second of the PRG signal being output from the main body ECU.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1242 | The applicable RDA signal cannot be received within 1 second of the PRG signal being output from the main body ECU. | ·
Harness or connector ·
Door control receiver ·
Main body ECU |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
When replacing the door control receiver, refer to the registration procedures (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)>REGISTRATION).
Clear the DTCs (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)>DTC CHECK / CLEAR).
NEXT
Check for DTCs (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)>DTC CHECK / CLEAR).
DTC B1242 is not output.
OK
NG
Disconnect the L47 receiver connector.
Disconnect the E118 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L47-2 (RDA) - E118-4 (RDA) | Always | Below 1 Ω |
| L47-3 (PRG) - E118-5 (PRG) | Always | Below 1 Ω |
| L47-2 (RDA) - Body ground | Always | 10 kΩ or higher |
| L47-3 (PRG) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the L47 receiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L47-1 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L47-5 (+B) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector
(to Door Control Receiver) |
OK
NG
Temporarily replace the door control receiver with a new one (See page Vehicle Interior>DOOR LOCK>DOOR CONTROL RECEIVER>REMOVAL).
Perform the registration procedures (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)>REGISTRATION).
NEXT
Clear the DTCs (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)>DTC CHECK / CLEAR).
NEXT
Check for DTCs (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)>DTC CHECK / CLEAR).
DTC B1242 is not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LHD) | B |
| NG (for RHD) | C |
A
B
C