Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System) › from 2015.08
RM2660E _58 Vehicle Interior _052838 DOOR LOCK _0255552 WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System) J

DOOR LOCK  WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)  No Answer-Back  


DESCRIPTION

In some cases, wireless door lock control functions are normal but the hazard warning light and/or wireless door lock buzzer answer-back function does not operate. In such cases, hazard warning light and wireless door lock buzzer signal outputs from the main body ECU may be malfunctioning.

WIRING DIAGRAM

B325985E40
3.635,2.792 4.854,3.094 1.219,0.302 10 false Main Body ECU 3.698,2.625 4.01,2.823 0.313,0.198 10 false A 2.542,3.583 4.438,3.875 1.896,0.292 10 false Cowl Side Junction Block LH 2.542,3.385 2.854,3.583 0.313,0.198 10 false 2H 3.552,1.573 3.865,1.771 0.313,0.198 10 false 21 2.313,1.573 2.677,1.875 0.365,0.302 10 false 29 3.813,1.677 4.385,1.927 0.573,0.25 10 false BZR 5.25,2.792 7.156,3.094 1.906,0.302 10 false Combination Meter Assembly 0.625,2.292 2.448,2.646 1.823,0.354 10 false Wireless Door Lock Buzzer 0.625,2.135 0.938,2.333 0.313,0.198 10 false A84 1.927,1.573 2.271,1.865 0.344,0.292 10 false 1 0.708,1.573 1.052,1.865 0.344,0.292 10 false 2 0.938,4.135 2.677,4.344 1.74,0.208 10 false : CAN Communication Line 0.927,1.656 1.083,1.854 0.156,0.198 10 false E 1.656,1.667 1.906,1.885 0.25,0.219 10 false +B

CAUTION / NOTICE / HINT

NOTICE:
·

The wireless door lock control system key reminder warning system uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the wireless door lock control system after confirming that the communication system is functioning properly.

·

If the main body ECU (cowl side junction block LH) is replaced, refer to the Entry and Start System (for Entry Function).



PROCEDURE

1.CUSTOMIZE SETTING
a.

Check the customize status of answer-back function has been default setting (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/o Entry and Start System)>CUSTOMIZE PARAMETERS).

Result
Result Proceed to
The customize status of answer-back function has been default setting. A
The customize status of answer-back function has not been default setting. B



A

2.CHECK WIRELESS DOOR LOCK CONTROL FUNCTIONS

B

2.CHECK WIRELESS DOOR LOCK CONTROL FUNCTIONS
a.

Check the wireless door lock control functions using the electrical key transmitter sub-assembly (See page Vehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM(w/ Entry and Start System)>OPERATION CHECK).

OK:

Wireless door lock control functions are operated normally.




OK

3.READ VALUE USING GTS (DOOR LOCK POSITION SWITCH)

NG

3.READ VALUE USING GTS (DOOR LOCK POSITION SWITCH)
a.

Use the Data List to check if the door lock positions are functioning properly.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
FR Door Lock Pos Front door RH unlock detection switch signal / LOCK or UNLOCK LOCK: Front door RH locked
UNLOCK: Front door RH unlocked
-
FL Door Lock Pos Front door LH unlock detection switch signal / LOCK or UNLOCK LOCK: Front door LH locked
UNLOCK: Front door LH unlocked
-
RR-Door Lock Pos SW Rear door RH unlock detection switch signal / ON or OFF ON: Rear door RH unlocked
OFF: Rear door RH locked
-
RL-Door Lock Pos SW Rear door LH unlock detection switch signal / ON or OFF ON: Rear door LH unlocked
OFF: Rear door LH locked
-

OK:

On tester screen, each item changes between LOCK and UNLOCK (ON and OFF) according to above chart.




OK

4.CHECK WIRELESS ANSWER-BACK OPERATION

NG

4.CHECK WIRELESS ANSWER-BACK OPERATION
a.

Check the wireless answer-back operation using the electrical key transmitter sub-assembly.

Result
Result Proceed to
Only wireless door lock buzzer answer-back does not occur. A
Only hazard warning light answer-back does not occur. B



A

B

5.CHECK HAZARD WARNING LIGHTS OPERATION
5.CHECK HAZARD WARNING LIGHTS OPERATION
a.

Check that the hazard warning signal light blinks when the hazard warning signal switch is pressed.

OK:

Hazard warning signal light is normal.



Result
Result Proceed to
OK (for LHD) A
OK (for RHD) B
NG C


A

B

C