Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM (w/ Entry and Start System) › 2015.08–2017.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255571 THEFT DETERRENT SYSTEM(w/ Entry and Start System) C

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM(w/ Entry and Start System)  B2768  Tilt Sensor Internal Circuit Malfunction  


DESCRIPTION

This DTC is stored when one of the following occurs: 1) theft warning tilt sensor (yaw rate sensor) power supply malfunction; 2) theft warning tilt sensor (yaw rate sensor) open malfunction; or 3) EEPROM malfunction.


DTC Code DTC Detection Condition Trouble Area
B2768 If one of the following is detected:
·

Theft warning tilt sensor (yaw rate sensor) power supply malfunction

·

Theft warning tilt sensor (yaw rate sensor) open malfunction

·

EEPROM malfunction


·

Theft warning tilt sensor (yaw rate sensor)

·

Main body ECU (multiplex network body ECU)



CAUTION / NOTICE / HINT

NOTICE:
·

If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.

·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

·

w/ Door Control Battery:

As the door control battery is installed between the vehicle battery and main body ECU (multiplex network body ECU), first perform the inspections in On-Vehicle Inspection to confirm that there are no malfunctions in the power source circuit for the main body ECU (multiplex network body ECU) before performing this troubleshooting procedure (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PRECAUTION).



PROCEDURE

1.CHECK FOR DTC

b.

Turn the engine switch on (IG), then off.


c.

Set the theft deterrent system to "ARMED STATE".


d.

Check that the security indicator changes from illuminated to blinking.


e.

Set the theft deterrent system to "DISARMED STATE".




OK

NG

2.REPLACE THEFT WARNING TILT SENSOR (YAW RATE SENSOR)
2.REPLACE THEFT WARNING TILT SENSOR (YAW RATE SENSOR)
a.

Temporarily replace the theft warning tilt sensor (yaw rate sensor) with a new or normally functioning one (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>TILT SENSOR>REMOVAL).



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC

b.

Turn the engine switch on (IG), then off.


c.

Set the theft deterrent system to "ARMED STATE".


d.

Check that the security indicator changes from illuminated to blinking.


e.

Set the theft deterrent system to "DISARMED STATE".


f.

Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM (w/ Entry and Start System)>DTC CHECK / CLEAR).

OK:

DTC B2768 is not output.


Result
Result Proceed to
DTC B2768 is not output. A
DTC B2768 is output. (for LHD) B
DTC B2768 is output. (for RHD) C



A

END (THEFT WARNING TILT SENSOR [YAW RATE SENSOR] WAS DEFECTIVE)

B

REPLACE MAIN BODY ECU (MULTIPLEXNETWORK BODY ECU)

C

REPLACE MAIN BODY ECU (MULTIPLEXNETWORK BODY ECU)