1. DISABLE AUTO TILT AWAY FUNCTION
Disable the Autoaway/Return function by changing the customize parameter (See page General>INTRODUCTION>REPAIR INSTRUCTION>CUSTOMIZE PARAMETERS).
Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.
Performing the above operation causes the Autoaway/Return function to be disabled when the engine switch is turned off.
Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.
Turn the engine switch off.
55474C
2.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55449C
3.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
55403C
4.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
55475A
5.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55404C
6.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
84119
7.REMOVE LIGHT CONTROL RHEOSTAT
Detach the 2 claws and remove the rheostat.