Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY(for Front Passenger Side) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255607 KNEE AIRBAG ASSEMBLY(for Front Passenger Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Front Passenger Side)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RHD and LHD.

·

The procedures listed below are the LHD side.



PROCEDURE

Hide 73990 1.INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

a.

Connect the connector.

B449547E01
0.354,0.083 1.115,0.385 0.76,0.302 12 false for LHD: 3.958,0.104 4.719,0.406 0.76,0.302 12 false for RHD:

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Attach the 4 claws to install the front passenger side knee airbag.


c.

Install the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 55607 2.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 55402C 3.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

Hide 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 7. CHECK SRS WARNING LIGHT