Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY(for Front Passenger Side) › from 2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255607 KNEE AIRBAG ASSEMBLY(for Front Passenger Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Front Passenger Side)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67914B 3.REMOVE FRONT DOOR SCUFF PLATE LH (for Double Swing Out Type Back Door)

Hide 67913B 4.REMOVE FRONT DOOR SCUFF PLATE RH (except Double Swing Out Type Back Door)

Hide 55449C 5.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION (for Double Swing Out Type Back Door)

Hide 55448A 6.REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION (except Double Swing Out Type Back Door)

Hide 55403C 7.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH (for Double Swing Out Type Back Door)

Hide 55402C 8.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH (except Double Swing Out Type Back Door)

Hide 55607 9.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 73990 10.REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY

a.
B427377E01
0.906,2.805 1.151,3.049 false 1.171,2.964 1.364,3.134 0.193,0.170 10 *a

Remove the 4 bolts.


b.

Detach the 4 claws and remove the front passenger side knee airbag assembly.


c.

Using a screwdriver, release the connector lock and disconnect the airbag connector.

Text in Illustration
*a Connector Lock
V100155

Protective Tape

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.


CAUTION:

Tape the screwdriver tip before use.