Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (- ) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55318C
3.REMOVE INSTRUMENT SIDE PANEL LH
67914B
4.REMOVE FRONT DOOR SCUFF PLATE LH
55606
5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62112
6.REMOVE COWL SIDE TRIM BOARD LH
55449C
7.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
55403C
8.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
55474C
9.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55475A
10.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55432D
11.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
55446A
12.REMOVE NO. 1 SWITCH HOLE BASE
13.REMOVE CURTAIN SHIELD AIRBAG CUTOFF SWITCH
Detach the 2 claws and remove the curtain shield airbag cutoff switch.