Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052844 PRE-CRASH SAFETY _0255621 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  B2036  Power Supply Relay Malfunction Open  


DESCRIPTION

If the seat belt control ECU judges that there is a malfunction in its internal circuit as a result of self-diagnosis, or if the power source voltage (+B) is not input to the seat belt control ECU, this DTC will be stored.

DTC Code DTC Detection Condition Trouble Area
B2036
·

Malfunction in seat belt control ECU

·

Power source voltage (+B) is not input to the seat belt control ECU.


·

Harness or connector

·

Fuse

·

Seat belt control ECU



WIRING DIAGRAM

E175293E10
5.333,2 6.146,2.688 0.813,0.688 10 false Seat Belt Control ECU 5.375,0.927 5.604,1.083 0.229,0.156 10 false +B 5.344,1.833 5.76,1.99 0.417,0.156 10 false E41 5.146,0.802 5.25,0.979 0.104,0.177 10 false 7 3.104,1.135 3.427,1.302 0.323,0.167 10 false PSB 0.719,0.906 1.542,1.24 0.823,0.333 10 false from Battery

CAUTION / NOTICE / HINT

CAUTION:

The pretensioner is built into the front seat outer belt assembly. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may deploy the pretensioner.


NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.INSPECT SEAT BELT CONTROL ECU (+B TERMINAL VOLTAGE)
a.
U165822E02
1.615,1.969 1.313,2.625 true 1.615,0.906 2.063,1.063 0.448,0.156 10 false E41 1.146,2.688 1.417,2.854 0.271,0.167 10 false +B 0.292,0.083 2.656,0.646 2.365,0.563 10 false Front view of wire harness connector: (to Seat Belt Control ECU)

Disconnect the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



b.

Disconnect the E41 connector of the seat belt control ECU.


c.

Connect the negative (-) battery terminal.


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
E41-7 (+B) - Body ground Always 11 to 14 V


Result
Result Proceed to
OK
(for LHD)
A
OK
(for RHD)
B
NG C


e.

Disconnect the negative (-) battery terminal.


f.

Reconnect the E41 seat belt control ECU connector.


g.

Connect the negative (-) battery terminal.



A

B

C

REPAIR OR REPLACE HARNESS OR CONNECTOR