1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Driver Side Knee Airbag)
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55449C
3.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
55403C
4.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
55474C
5.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55475A
6.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55606
7.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)
73900
8.REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)
55303B
9.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)
55446A
10.REMOVE NO. 1 SWITCH HOLE BASE
55432D
11.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
89815
12.REMOVE SEAT BELT CONTROL ECU
Disconnect the 2 connectors.
Remove the 2 nuts and remove the seat belt control ECU together with the certification ECU.
Remove the bolt and seat belt control ECU from the certification ECU.