Home › Vehicle Interior › PRE-CRASH SAFETY › SEAT BELT CONTROL ECU(for RHD) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052844 PRE-CRASH SAFETY _0255620 SEAT BELT CONTROL ECU(for RHD) A

PRE-CRASH SAFETY  SEAT BELT CONTROL ECU(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Passenger Side Knee Airbag)

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55403C 4.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

Hide 55607 5.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 73990 6.REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)

Hide 55312 7.REMOVE LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)

Hide 55476A 8.REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55433B 9.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Hide 89815 10.REMOVE SEAT BELT CONTROL ECU

E155219

a.

Disconnect the 2 connectors.


b.

Remove the nut and ECU.