This DTC is stored when there is a malfunction in the communication from the millimeter wave radar sensor. This DTC is also stored when the vehicle information sent from the millimeter wave radar sensor is abnormal.
In these cases, perform initialization so that the millimeter wave radar sensor recognizes the vehicle information.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2055 | There is a malfunction in the millimeter wave radar sensor or there is a problem with the initialization. | ·
Millimeter wave radar sensor ·
Seat belt control ECU ·
Distance control ECU |
Using the intelligent tester, enter the following menus: Powertrain / Radar Cruise / Trouble Code.
Clear the DTC (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Perform the following to make sure the DTC detection conditions are met.
If the detection conditions are not met, the system cannot detect the malfunction.
Drive the vehicle at a speed of 40 km/h (25 mph) or more.
Turn the cruise control main switch on to set the vehicle-to-vehicle distance control mode to the standby state.
Check for DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
DTC P1570 is not output.
OK
NG
Using the intelligent tester, enter the following menus: Body / Pre-Crash / Trouble Code.
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| OK
(DTC B2055 is not output) |
A |
| NG
(for LHD) |
B |
| NG
(for RHD) |
C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C