This DTC is stored when a malfunction in the vehicle stability control system is detected. This circuit consists of the master cylinder solenoid (skid control ECU) and seat belt control ECU. Signals are sent from the master cylinder solenoid (skid control ECU) via the CAN communication line.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2060 | Malfunction in the brake system is detected. | ·
CAN communication system ·
Vehicle stability control system ·
Seat belt control ECU |
Use the intelligent tester to check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM for LHD, Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM for RHD).
| Result | Proceed to |
|---|---|
| OK
(DTC U0122 is not output) |
A |
| NG
(for LHD) |
B |
| NG
(for RHD) |
C |
DTC U0122: Lost Communication with Skid Control ECU
A
B
C
Using the intelligent tester, enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Code.
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
DTC is not output.
OK
NG
Using the intelligent tester, enter the following menus: Body / Pre-Crash / Trouble Code.
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| OK
(DTC B2060 is not output) |
A |
| NG
(for LHD) |
B |
| NG
(for RHD) |
C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C