Home › Vehicle Interior › HEATING / AIR CONDITIONING › REAR AIR CONDITIONING UNIT (w/o Heater)
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255672 REAR AIR CONDITIONING UNIT(w/o Heater) A

HEATING / AIR CONDITIONING  REAR AIR CONDITIONING UNIT(w/o Heater)  INSTALLATION  


PROCEDURE

Hide 87030A 1.INSTALL REAR COOLING UNIT ASSEMBLY

a.

Install the rear cooling unit as shown in the illustration.

E156487


b.
E154871

Install the 4 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the connector.


Hide 88566R 2.INSTALL REAR ROOF NO. 1 AIR DUCT

E154870

a.

Install the duct with the clip.


b.
E154869

Attach the 2 claws to install the cooler plate.


Hide 88790E 3.CONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY

E154366

a.

Remove the attached vinyl tape from the pipe.


b.

Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the air conditioner tube and accessory assembly.


c.

Install the 2 O-rings to the air conditioner tube and accessory assembly.


d.

Connect the air conditioner tube and accessory assembly.


e.

Install the 2 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 62520P 4.INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

Hide 71845B 5.INSTALL REAR SEAT COVER CAP (w/ Rear No. 2 Seat)

Hide 64910J 6.INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 58574A 8.INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

Hide 9.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 53292A 14.INSTALL UPPER RADIATOR SUPPORT SEAL