When the integration control and panel assembly is turned to ECO position, the air conditioning amplifier assembly controls the air conditioning system to enhance fuel efficiency.
w/ Rear Heater:
w/o Rear Heater:
Use the Data List to check if the integration control and panel assembly is functioning properly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Control Range | Diagnostic Note |
|---|---|---|---|
| ECO Switch | Integration control and panel assembly / OFF or ON | ON: Integration control and panel assembly being turned and held at ECO position
OFF: Integration control and panel assembly not turned |
- |
The integration control and panel assembly condition displayed on the GTS changes with the actual switch operation.
OK
NG
Remove the integration control and panel assembly.
for A750F: See page Drivetrain>A750F (AUTOMATIC TRANSMISSION / TRANSAXLE)>COMBINATION SWITCH>REMOVAL
Inspect the integration control and panel assembly.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for AB60F) | B |
| NG (A750F) | C |
A
B
C
w/ Rear Heater:
Disconnect the V9 integration control and panel assembly connector.
Disconnect the E36 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V9-6 (ECU) - E36-29 (ECOS) | Always | Below 1 Ω |
| V9-5 (E) - Body ground | Always | Below 1 Ω |
| V9-6 (ECU) or E36-29 (ECOS) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V9-3 (ECU) - E36-29 (ECOS) | Always | Below 1 Ω |
| V9-5 (E) - Body ground | Always | Below 1 Ω |
| V9-3 (ECU) or E36-29 (ECOS) - Body ground | Always | 10 kΩ or higher |
w/o Rear Heater:
Disconnect the V9 integration control and panel assembly connector.
Disconnect the 165 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V9-6 (ECU) - E165-6 (ECOS) | Always | Below 1 Ω |
| V9-5 (E) - Body ground | Always | Below 1 Ω |
| V9-6 (ECU) or E165-6 (ECOS) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| V9-3 (ECU) - E165-6 (ECOS) | Always | Below 1 Ω |
| V9-5 (E) - Body ground | Always | Below 1 Ω |
| V9-3 (ECU) or E165-6 (ECOS) - Body ground | Always | 10 kΩ or higher |
OK
NG