When the idle up switch is pushed, the air conditioning amplifier assembly outputs the engine idle up signal. If engine idle up does not occur when the idle up switch is pushed, there may be a problem in the circuit shown below.
w/ Rear Heater:
w/o Rear Heater:
Use the Data List to check if the idle up switch is functioning properly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| IDLE UP/PWR HEAT Switch | Idle up switch/ON or OFF | ON: Idle up switch on
OFF: Idle up switch off |
- |
The display is as specified in the normal condition column.
OK
NG
Remove the idle up switch (See page Vehicle Interior>HEATING / AIR CONDITIONING>HEATER SWITCH>REMOVAL).
Inspect the idle up switch (See page Vehicle Interior>HEATING / AIR CONDITIONING>HEATER SWITCH>INSPECTION).
OK
NG
w/ Rear Heater:
Disconnect the E97 idle up switch connector.
Disconnect the E35 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E97- 6 (+S) - E35-28 (SW 1) | Always | Below 1 Ω |
| E97-3 (E) - Body ground | Always | Below 1 Ω |
| E97- 6 (+S) or E35-28 (SW 1) - Body ground | Always | 10 kΩ or higher |
w/o Rear Heater:
Disconnect the E97 idle up switch connector.
Disconnect the E81 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E97- 6 (+S) - E81-4 (SW 1) | Always | Below 1 Ω |
| E97-3 (E) - Body ground | Always | Below 1 Ω |
| E97- 6 (+S) or E81-4 (SW 1) - Body ground | Always | 10 kΩ or higher |
OK
NG