Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) › from 2015.08
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255703 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  Idle Up Switch Circuit  


DESCRIPTION

When the idle up switch is pushed, the air conditioning amplifier assembly outputs the engine idle up signal. If engine idle up does not occur when the idle up switch is pushed, there may be a problem in the circuit shown below.

WIRING DIAGRAM

E337638E06
5.406,0.906 5.875,1.104 0.469,0.198 10 false SW 1 5.167,1.75 5.635,1.948 0.469,0.198 10 false E81 5.167,1.969 6.76,2.333 1.594,0.365 10 false Air Conditioning Amplifier Assembly 3.26,1.323 3.729,1.521 0.469,0.198 10 false E97 3.271,1.49 4.198,1.708 0.927,0.219 10 false Idle Up Switch 4.271,0.906 4.563,1.104 0.292,0.198 10 false +S 2.938,0.906 3.229,1.104 0.292,0.198 10 false E 5.198,0.896 5.438,1.094 0.24,0.198 10 false 4 4.583,0.906 4.823,1.104 0.24,0.198 10 false 6 2.719,0.917 2.958,1.115 0.24,0.198 10 false 3

PROCEDURE

1.READ VALUE USING GTS (IDLE UP/PWR HEAT SWITCH)
a.

Use the Data List to check if the idle up switch is functioning properly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)>DATA LIST / ACTIVE TEST).

Tester Display Measurement Item/Range Normal Condition Diagnostic Note
IDLE UP/PWR HEAT Switch Idle up switch/ON or OFF ON: Idle up switch on
OFF: Idle up switch off
-

OK:

The display is as specified in the normal condition column.




OK

2.INSPECT IDLE UP SWITCH

NG

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

2.INSPECT IDLE UP SWITCH

OK

3.CHECK HARNESS AND CONNECTOR (IDLE UP SWITCH - AIR CONDITIONING AMPLIFIER ASSEMBLY AND BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (IDLE UP SWITCH - AIR CONDITIONING AMPLIFIER ASSEMBLY AND BODY GROUND)
a.

Disconnect the E97 idle up switch connector.


b.

Disconnect the E81 air conditioning amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E97- 6 (+S) - E81-4 (SW 1) Always Below 1 Ω
E97-3 (E) - Body ground Always Below 1 Ω
E97- 6 (+S) or E81-4 (SW 1) - Body ground Always 10 kΩ or higher




OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR