Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PANEL (w/ Navigation System) › from 2015.08
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255706 AIR CONDITIONING PANEL(w/ Navigation System) A

HEATING / AIR CONDITIONING  AIR CONDITIONING PANEL(w/ Navigation System)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LHD vehicle and RHD vehicle.

·

The procedures listed below are for the LHD vehicle.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55510F 3.REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY

Hide 55670 4.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55680A 5.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55449C 7.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 55403C 8.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

Hide 55448A 9.REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 55402C 10.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

Hide 55406B 11.REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 86130A 12.REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY

E338538

a.

Remove the 2 bolts and 2 screws.


b.
E338535

Pull the multi-media module receiver assembly to detach the 5 claws on the backside of the multi-media module receiver assembly.


c.

Disconnect each connector and remove the multi-media module receiver assembly.