Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
82142
1.INSTALL NO. 2 INSTRUMENT PANEL WIRE (for LHD)
Attach the clamps to install the No. 2 instrument panel wire to the instrument panel.
82142
2.INSTALL NO. 2 INSTRUMENT PANEL WIRE (for RHD)
Attach the clamps to install the No. 2 instrument panel wire to the instrument panel.
86101
3.INSTALL ANTENNA CORD SUB-ASSEMBLY (w/o Multi-display)
86101
4.INSTALL ANTENNA CORD SUB-ASSEMBLY (w/ Multi-display)
86860
5.INSTALL NAVIGATION ANTENNA ASSEMBLY (w/ Multi-display)
55962
6.INSTALL NO. 2 SIDE DEFROSTER NOZZLE
Attach the 3 claws to install the No. 2 side defroster nozzle.
55961B
7.INSTALL NO. 1 SIDE DEFROSTER NOZZLE
Attach the 2 claws to install the No. 1 side defroster nozzle.
55950G
8.INSTALL DEFROSTER NOZZLE ASSEMBLY
Attach the 11 claws to install the defroster nozzle.
73960A
9.INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
87212
10.INSTALL REAR NO. 1 AIR DUCT (w/ Rear Air Duct)
Install the rear No. 1 air duct with the 2 screws.
55835A
11.INSTALL CENTER HEATER TO REGISTER DUCT
Install the center heater to register duct with the 3 screws.