Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows) › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052850 WINDOW / GLASS _0255725 POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows) J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows)  Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch  


DESCRIPTION

If the auto up/down function does not operate, the cause may be one or more of the following:


·

The ECU in the power window regulator motor determines that the power window regulator motor has not been initialized.

·

The master switch has a malfunction.

·

The Hall-IC in the driver side power window regulator motor has a malfunction.

·

There is an open or short in the wiring between the master switch and the driver side power window regulator motor.


PROCEDURE

2.CHECK MANUAL UP/DOWN FUNCTION
a.

Check that the driver side door power window moves when the manual up/down function of the multiplex network master switch is operated (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows)>OPERATION CHECK).

OK:

Driver side door power window moves.




OK

3.READ VALUE USING INTELLIGENT TESTER (MULTIPLEX NETWORK MASTER SWITCH)

NG

3.READ VALUE USING INTELLIGENT TESTER (MULTIPLEX NETWORK MASTER SWITCH)
a.

Use the Data List to check if the master switch is functioning properly (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(for Models with Jam Protection Function on 4 Windows)>DATA LIST / ACTIVE TEST).

Master Switch
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
D Door P/W Auto SW Driver side power window auto up/down signal / ON or OFF ON: Driver side power window auto up/down switch operated
OFF: Driver side power window switch not operated
-

OK:

The display changes according to operation of the multiplex network master switch.


Result
Result Proceed to
NG A
OK (for LHD) B
OK (for RHD) C



A

REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY

B

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

C

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH