Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Front Door) › from 2015.08
RM2660E _59 Vehicle Exterior _052850 WINDOW / GLASS _0255729 POWER WINDOW REGULATOR MOTOR(for Front Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Front Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 85720C 1.INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY

a.

Apply MP grease to the sliding and rotating areas of the regulator motor.


b.

Using a T25 "TORX" driver, install the front power window regulator motor assembly with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

A new front power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 69802 2.INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY

Hide 68102 3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67832 4.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 67602 6.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74646 7.INSTALL DOOR ASSIST GRIP COVER

Hide 74240A 8.INSTALL FRONT DOOR ARMREST BASE PANEL ASSEMBLY

Hide 69278B 9.INSTALL FRONT DOOR INSIDE HANDLE BEZEL

Hide 67492A 10.INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).