Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for LHD vehicles.
85943
1.INSTALL WINDSHIELD WIPER ECU
Install the windshield wiper ECU with the screw.
Connect the 2 connectors.
55433B
2.INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
55443D
3.INSTALL INSTRUMENT PANEL BOX DOOR KNOB
55476A
4.INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55312
5.INSTALL LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)
73990
6.INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)
67913B
7.INSTALL FRONT DOOR SCUFF PLATE RH
55607
8.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)
55317A
9.INSTALL INSTRUMENT SIDE PANEL RH (w/ Airbag Cut Off Switch)
55317A
10.INSTALL INSTRUMENT SIDE PANEL RH (w/o Airbag Cut Off Switch)
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
12.CHECK SRS WARNING LIGHT