Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
85940
1.INSTALL WINDSHIELD WIPER RELAY ASSEMBLY
Attach the guide and install the windshield wiper relay assembly with the screw.
Connect the connector.
55433B
2.INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
55443D
3.INSTALL INSTRUMENT PANEL BOX DOOR KNOB
55476A
4.INSTALL NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH
73990
5.INSTALL FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY
62111C
6.INSTALL COWL SIDE TRIM BOARD RH
55607
7.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)
67913B
8.INSTALL FRONT DOOR SCUFF PLATE RH
55317A
9.INSTALL INSTRUMENT SIDE PANEL RH
55402C
10.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
55448A
11.INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION
12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
13.CHECK SRS WARNING LIGHT
Check the SRS warning light (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).