Home › Vehicle Exterior › WIPER / WASHER › WIPER ECU › from 2015.08
RM2660E _59 Vehicle Exterior _052854 WIPER / WASHER _0255781 WIPER ECU A

WIPER / WASHER  WIPER ECU  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55448A 3.REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

Hide 55402C 4.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

Hide 55607 7.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 55476A 10.REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55443D 11.REMOVE INSTRUMENT PANEL BOX DOOR KNOB

Hide 55433B 12.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Hide 85940 13.REMOVE WINDSHIELD WIPER RELAY ASSEMBLY

a.
B427778

Disconnect the connector.


b.

Remove the screw.


c.

Detach the 2 guides and remove the windshield wiper relay assembly