Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
81150
1.INSTALL HEADLIGHT ASSEMBLY LH
Set the headlight assembly LH in place.
Install the bolt and 3 screws.
Connect the 2 connectors.
53883F
2.INSTALL FRONT FENDER MAIN SEAL LH
52119A
3.INSTALL FRONT BUMPER COVER
for Standard:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(for Standard)>INSTALLATION)
w/ Winch:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER(w/ Winch)>INSTALLATION)
4.ADJUST HEADLIGHT AIMING
5.ADJUST FOG LIGHT AIMING