Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH › 2014.08–2015.08
RM2660E _59 Vehicle Exterior _052855 LIGHTING (EXT) _0255805 HAZARD WARNING SWITCH A

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RHD and LHD.

·

The procedures listed below are the LHD side.



PROCEDURE

Hide 84330 1.INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY

a.
E155869

Attach the 2 claws to install the hazard warning switch.


Hide 55412C 2.INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (w/o Radio Receiver)

Hide 55680A 4.INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55670 5.INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55510F 6.INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).