Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE (for Front Door) › from 2015.08
RM2660E _59 Vehicle Exterior _052857 EXTERIOR PANELS / TRIM _0255851 BLACK OUT TAPE(for Front Door) A

EXTERIOR PANELS / TRIM  BLACK OUT TAPE(for Front Door)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

When removing the No. 1 black out tape LH, No. 3 black out tape LH, No. 4 black out tape LH and front door rear window frame moulding LH, heat the vehicle body, No. 1 black out tape LH, No. 3 black out tape LH, No. 4 black out tape LH and front door rear window frame moulding LH using a heat light.



Standard Heating Temperature:
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
No. 1 Black Out Tape LH 20 to 30°C (68 to 86°F)
No. 3 Black Out Tape LH 20 to 30°C (68 to 86°F)
No. 4 Black Out Tape LH 20 to 30°C (68 to 86°F)
Front Door Rear Window Frame Moulding LH 20 to 30°C (68 to 86°F)


NOTICE:

Do not heat the vehicle body, No. 1 black out tape LH, No. 3 black out tape LH, No. 4 black out tape LH and front door rear window frame moulding LH excessively.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67492A 3.REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH

Hide 69278B 4.REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

Hide 74232 5.REMOVE FRONT UPPER ARMREST BASE PANEL LH

Hide 74646 6.REMOVE DOOR ASSIST GRIP COVER LH

Hide 67602 7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 87940 8.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

Hide 67832 9.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 68172A 10.REMOVE FRONT INNER DOOR GLASS WEATHERSTRIP LH

Hide 68102 11.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

Hide 68151E 12.REMOVE FRONT DOOR GLASS RUN LH

Hide 75720 13.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY LH

Hide 75756C 14.REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING LH

Hide 67674 15.REMOVE LOWER DOOR FRAME GARNISH LH

Hide 68620 16.REMOVE FRONT DOOR CHECK ASSEMBLY LH

Hide 67862 17.REMOVE FRONT DOOR WEATHERSTRIP LH

a.
B433685

w/o Spot Cover:

i.

Detach the 6 clips, and remove the upper part of the front door weatherstrip LH so that the black out tape can be removed.



b.

w/ Spot Cover:

i.

Remove the front door weatherstrip LH (See page Vehicle Exterior>DOOR / HATCH>FRONT DOOR>DISASSEMBLY).



Hide 75922M 18.REMOVE NO. 1 BLACK OUT TAPE LH

B182610

a.

Pull back an edge of the No. 1 black out tape LH and pull it parallel to the vehicle body to remove it.


Hide 75926A 19.REMOVE NO. 3 BLACK OUT TAPE LH

B182612

a.

Pull back an edge of the No. 3 black out tape LH and pull it parallel to the vehicle body to remove it.


Hide 75928B 20.REMOVE NO. 4 BLACK OUT TAPE LH

B182614

a.

Pull back an edge of the No. 4 black out tape LH and pull it parallel to the vehicle body to remove it.