Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › 2014.08–2015.08
RM2660E _53 Suspension _052817 TIRE PRESSURE MONITORING _0255402 TIRE PRESSURE WARNING SYSTEM Y

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the tire pressure warning system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.ADJUST TIRE PRESSURE*
2.ADJUST TIRE PRESSURE*
a.

Turn the engine switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the engine switch on (IG).


d.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.


e.

Set the pressure of each tire to the specified value

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION

NOTICE:

Make sure the tires are cooled down when adjusting the tire pressure.



f.

Display "ID Tire Inflation Pressure" in the Data List and check that tire pressure data matches the adjusted tire pressure.

HINT:

It takes a few minutes to display the updated tire pressure data.



g.

Perform initialization.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION

HINT:

The warning threshold value changes depending on the driving conditions during initialization. As a result, the tire pressure warning light may not turn off even if the tire pressure is adjusted to the specified pressure.



Result:
Result Proceed to
Tire pressure warning light remains on A
Tire pressure warning light goes off B



A

3.CHECK ECU CONNECTED TO CAN BUS*

B

9.CONFIRMATION TEST*
3.CHECK ECU CONNECTED TO CAN BUS*

Result:
Result Proceed to
No malfunction appears A
Malfunction appears (for LHD) B
Malfunction appears (for RHD) C



A

4.CHECK FOR DTC*

B

C

4.CHECK FOR DTC*

Result:
Result Proceed to
DTC is output A
DTC is not output B



A

5.DTC CHART

B

6.PROBLEM SYMPTOMS TABLE
5.DTC CHART

Result:
Proceed to
NEXT



NEXT

8.REPAIR OR REPLACE
6.PROBLEM SYMPTOMS TABLE

Result:
Proceed to
NEXT



NEXT

7.CIRCUIT INSPECTION*
7.CIRCUIT INSPECTION*

Result:
Proceed to
NEXT



NEXT

8.REPAIR OR REPLACE
8.REPAIR OR REPLACE
a.

Repair or replace parts based on the diagnosis result.


Result:
Proceed to
NEXT



NEXT

9.CONFIRMATION TEST*
9.CONFIRMATION TEST*
a.

Check the Data List to confirm that the tire inflation pressure has been received.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST



c.

Confirm that the initialization has been completed.


Result:
Proceed to
NEXT



NEXT

END