The main body ECU (multiplex network body ECU) sends signals to the tire pressure warning ECU and receiver via a direct line.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C2179/79 | Communication between the main body ECU (multiplex network body ECU) and tire pressure warning ECU and receiver is interrupted for 10 seconds or more. | ·
Main body ECU (Multiplex network body ECU) ·
Wire harness or connector ·
Tire pressure warning ECU and receiver |
When replacing the tire pressure warning ECU and receiver, read the IDs stored in the old ECU using the GTS and write them down before removal.
It is necessary to perform initialization (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION) after registration (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>REGISTRATION) of the transmitter IDs into the tire pressure warning ECU and receiver after the ECU has been replaced.
If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.
Turn the ignition switch off.
Disconnect the L65*1 or L75*2 tire pressure warning ECU and receiver connector.
*1: w/o Front Antenna
*2: w/ Front Antenna
Disconnect the E118 main body ECU (multiplex network body ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| L65-5 (PRG) - E118-5 (PRG)*1
L75-5 (PRG2) - E118-5 (PRG)*2 |
Always | Below 1 Ω |
| L65-5 (PRG) or E118-5 (PRG) - Body ground*1
L75-5 (PRG2) or E118-5 (PRG) - Body ground*2 |
Always | 10 kΩ or higher |
*1: w/o Front Antenna
*2: w/ Front Antenna
OK
NG
Replace the tire pressure warning ECU and receiver (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING RECEIVER>REMOVAL).
NEXT
Clear the DTCs (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR).
Turn the ignition switch off.
Turn the ignition switch to ON.
Check for DTCs (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to | |
|---|---|---|
| DTC C2179/79 is not output. | A | |
| DTC C2179/79 is output. | for LHD | B |
| for RHD | C | |
A
B
C