Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR BUMPER
for Double Swing Out Type:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(for Double Swing Out Type)>REMOVAL
for Standard:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(for Standard)>REMOVAL
w/ Pintle Hook:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(w/ Pintle Hook)>REMOVAL
81490C
2.REMOVE REAR FOG LIGHT ASSEMBLY LH
for Double Swing Out Type:
Disconnect the connector.
Remove the 2 nuts.
Detach the claw and remove the rear fog light assembly LH.
except Double Swing Out Type:
Disconnect the connector and detach the wire harness clamp.
Remove the 3 screws and rear fog light assembly LH.