If the bumper is damaged, there is a possibility that the installation area of the blind spot monitor sensor may be deformed and the blind spot monitor system may not operate correctly, so visually inspect the blind spot monitor sensor installation area (frame, stud bolt) to make sure it is not dented or bent.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK
If the visual inspection finds a problem, check the installation condition of the blind spot monitor sensor, and adjust the installation position of the blind spot monitor sensor as necessary.
51937C
1.REMOVE SPARE WHEEL CARRIER HINGE BRACKET (w/ Tire Carrier)
51902A
2.REMOVE SPARE WHEEL COVER SUB-ASSEMBLY (w/ Tire Carrier)
51903B
3.REMOVE SPARE WHEEL CARRIER SUB-ASSEMBLY (w/ Tire Carrier)
51980A
4.REMOVE PINTLE HOOK ASSEMBLY (w/ Pintle Hook)
76626E
5.REMOVE REAR QUARTER PANEL MUDGUARD LH
76625G
6.REMOVE REAR QUARTER PANEL MUDGUARD RH
52162B
7.REMOVE REAR BUMPER NO. 1 PLATE
Put protective tape around the rear bumper No. 1 plate.
| *1 | Protective Tape |
Detach the 20 claws and remove the rear bumper No. 1 plate.
52159
8.REMOVE REAR BUMPER COVER
Remove the 6 screws, 2 clips and 2 bolts.
Remove the 2 clips and 5 bolts.
Put protective tape around the rear bumper cover.
| *1 | Protective Tape | - | - |
Open the back doors one notch.
Disconnect the No. 2 frame wire connector.
Detach the 14 claws and remove the rear bumper cover.
9.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
10.REMOVE REAR COMBINATION LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
52563D
11.REMOVE REAR BUMPER UPPER RETAINER LH
Detach the 2 clips and remove the rear bumper upper retainer.
52562E
12.REMOVE REAR BUMPER UPPER RETAINER RH
Use the same procedure described for the LH side.
52156A
13.REMOVE REAR BUMPER SIDE SUPPORT LH
Remove the 3 screws.
Detach the 6 claws and remove the rear bumper side support.
52155A
14.REMOVE REAR BUMPER SIDE SUPPORT RH
Use the same procedure described for the LH side.
52172B
15.REMOVE REAR BUMPER NO. 2 REINFORCEMENT
Remove the 2 bolts and rear bumper No. 2 reinforcement.
57615C
16.REMOVE REAR BUMPER ARM BRACKET
Use the same procedure for both rear bumper arm brackets.
Remove the bolt and rear bumper arm bracket.
57616B
17.REMOVE REAR BUMPER ARM BRACKET LH
Detach the clamp.
Remove the 2 bolts and nut and remove the rear bumper arm bracket.
58724B
18.REMOVE NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Remove the 2 screws, 2 grommets and No. 2 luggage compartment side cover protector.
58723B
19.REMOVE NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Use the same procedure described for the No. 2 luggage compartment side cover protector.