Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM (w/ Entry and Start System) › from 2017.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255571 THEFT DETERRENT SYSTEM(w/ Entry and Start System) C

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM(w/ Entry and Start System)  B2761  Intrusion Sensor Internal Circuit Malfunction  


DESCRIPTION

The intrusion and tilt sensor (theft warning ultrasonic sensor) conducts self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).

If a problem is detected in the signals transmitted and received by the intrusion and tilt sensor (theft warning ultrasonic sensor), or if the transmission or reception circuits malfunction, the intrusion and tilt sensor (theft warning ultrasonic sensor) transmits a signal to the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) then stores this DTC.


DTC Code DTC Detection Condition Trouble Area
B2761 Intrusion and tilt sensor (theft warning ultrasonic sensor) outputs signal for sensor malfunction
·

Intrusion and tilt sensor (theft warning ultrasonic sensor)

·

Main body ECU (multiplex network body ECU)



CAUTION / NOTICE / HINT

NOTICE:
·

If the main body ECU (multiplex network body ECU) is replaced, refer to the Service Bulletin.

·

w/ Door Control Battery:

As the door control battery is installed between the vehicle battery and main body ECU (multiplex network body ECU), first perform the inspections in On-Vehicle Inspection to confirm that there are no malfunctions in the power source circuit for the main body ECU (multiplex network body ECU) before performing this troubleshooting procedure (See page Vehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PRECAUTION).



PROCEDURE

1.CHECK FOR DTC

b.

Turn the engine switch on (IG), then off.


c.

Set the theft deterrent system to "ARMED STATE".


d.

Check that the security indicator changes from illuminated to blinking.


e.

Set the theft deterrent system to "DISARMED STATE".




OK

NG

2.REPLACE INTRUSION AND TILT SENSOR (THEFT WARNING ULTRASONIC SENSOR)
2.REPLACE INTRUSION AND TILT SENSOR (THEFT WARNING ULTRASONIC SENSOR)
a.

Temporarily replace the intrusion and tilt sensor (theft warning ultrasonic sensor) with a new or normally functioning one (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>INTRUSION SENSOR>REMOVAL).



NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC

b.

Turn the engine switch on (IG), then off.


c.

Set the theft deterrent system to "ARMED STATE".


d.

Check that the security indicator changes from illuminated to blinking.


e.

Set the theft deterrent system to "DISARMED STATE".


f.

Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM (w/ Entry and Start System)>DTC CHECK / CLEAR).

OK:

DTC B2761 is not output.


Result
Result Proceed to
DTC B2761 is not output A
DTC B2761 is output (for LHD) B
DTC B2761 is output (for RHD) C



A

END (INTRUSION AND TILT SENSOR [THEFT WARNING ULTRASONIC SENSOR] WAS DEFECTIVE)

B

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

C

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)