1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
35000
3.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
33030
4.REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY
31210
5.REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)
31250
6.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)
32101
7.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)
13405
8.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)
11381A
9.REMOVE REAR CRANKSHAFT OIL SEAL
| *1 | Rear Crankshaft Oil Seal |
| *a | Cut Position |
Using a knife, cut off the lip of the oil seal.
Using a screwdriver, pry out the oil seal.
Be careful not to damage the crankshaft.
Tape the screwdriver tip before use.