Home › Drivetrain › JF2BM (TRANSFER / 4WD / AWD) › TRANSFER SYSTEM
RM38G0E _52 Drivetrain _100437 JF2BM TRANSFER / 4WD / AWD _0467431 TRANSFER SYSTEM C

JF2BM TRANSFER / 4WD / AWD  TRANSFER SYSTEM  P17F813  4WD/AWD Transfer Case H-L Motor Circuit Open  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
P17F813 4WD/AWD Transfer Case H-L Motor Circuit Open
Diagnosis Condition:
·

High-low transfer shift motor operating


Malfunction Status:
·

Open circuit in high-low transfer shift motor drive circuit


Malfunction Time:
·

5 seconds or more


Number of Trips:
·

1 trip


·

Wire harness and connector

·

Transfer shift actuator assembly

·

4 wheel drive control ECU


Four Wheel Drive

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (4 WHEEL DRIVE CONTROL ECU - HIGH-LOW SHIFT ACTUATOR (TRANSFER SHIFT ACTUATOR ASSEMBLY))
a.

Disconnect the B11 4 wheel drive control ECU connector.


b.

Disconnect the C48 high-low shift actuator (transfer shift actuator assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(B11,C48)Location & Routing

Click Connector(B11)Instrument Panel>Engine Room Main Wire / Heater Blower Wire>4 Wheel Drive Control ECU

Click Connector(C48)Engine Compartment>Connecting Wire / Cooling Fan Wire / Engine Wire / Fuel Pump Motor Wire / No. 1 Connecting Wire / No. 10 Engine Wire / No. 2 Connecting Wire / No. 3 Connecting Wire / No. 4 Connecting Wire / Sensor Wire / Turbocharger Wire>Transfer Assembly

B11-6 (HM1) - C48-1 (HM1) Always Below 1 Ω
B11-7 (HM2) - C48-2 (HM2) Always Below 1 Ω
B11-6 (HM1) or C48-1 (HM1) - Body ground Always 10 kΩ or higher
B11-7 (HM2) or C48-2 (HM2) - Body ground Always 10 kΩ or higher



d.

Connect the B11 4 wheel drive control ECU connector.


e.

Connect the C48 high-low shift actuator (transfer shift actuator assembly) connector.


Result:
Proceed to
OK
NG



OK

2.INSPECT HIGH-LOW SHIFT ACTUATOR (TRANSFER SHIFT ACTUATOR ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT HIGH-LOW SHIFT ACTUATOR (TRANSFER SHIFT ACTUATOR ASSEMBLY)
a.

Inspect the high-low shift actuator (transfer shift actuator assembly).

Click hereDrivetrain>JF2BM (TRANSFER / 4WD / AWD)>TRANSFER ASSEMBLY>INSPECTION


Result:
Proceed to
OK
NG



OK

NG

REPLACE TRANSFER SHIFT ACTUATOR ASSEMBLY