The steering lock ECU and steering lock motor are built into the steering lock actuator with ECU assembly.
The steering lock ECU (steering lock actuator with ECU assembly) detects whether the steering lock is in the lock or unlock position by using the lock sensor and unlock sensor of the steering lock motor.
The steering lock ECU (steering lock actuator with ECU assembly) receives lock and unlock request signals from the certification ECU (smart key ECU assembly) and responds with lock and unlock operation signals.
The steering lock ECU (steering lock actuator with ECU assembly) is not connected to the CAN communication system. However, the steering lock ECU (steering lock actuator with ECU assembly) is connected to the certification ECU (smart key ECU assembly) via LIN communication and communicates with other components via CAN communication through the certification ECU (smart key ECU assembly).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority | Note |
|---|---|---|---|---|---|---|
| B278196 | Steering Lock System Component Internal Failure | One of the following conditions is met (1-trip detection logic (Only output while a malfunction is present and the ignition switch is ON.)):
·
The steering lock sensor or unlock sensor is malfunctioning (When both detection switches turn on, the system is determined to be malfunctioning).
·
The steering lock motor activation circuit has a short circuit.
·
The steering lock motor activation circuit has an open circuit. |
·
Steering lock ECU (steering lock actuator with ECU assembly)
·
LIN communication system |
Entry&Start | B | DTC Output Confirmation Operation: No confirmation operation is necessary (monitoring is continuous). |
| Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
|---|---|
| The steering cannot be locked or unlocked. For this reason, the engine cannot be started. | Prohibits the engine from being started (the engine does not start). |
| DTC No. | Data List and Active Test |
|---|---|
| B278196 |
Entry&Start
·
Sensor Malfunction History
·
Motor Driver Short History
·
Lock Bar Stuck Error History |
When using the GTS with the ignition switch off, connect the GTS to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start(CAN). While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.
The entry and start system (for Start Function) uses the LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the entry and start system (for Start Function) after confirming that the communication systems are functioning properly.
Before replacing the steering lock ECU (steering lock actuator with ECU assembly), refer to Service Bulletin.
After performing repairs, confirm that no DTCs are output again.
When all the ECUs that are connected via LIN communication cannot communicate with the certification ECU (smart key ECU assembly), DTC B278588 is stored.
Using the GTS, check if LIN communication DTC B278588 is output.
If a LIN communication DTC is output, perform troubleshooting for the LIN communication system.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
| Result | Proceed to |
|---|---|
| B278588 is output | A |
| B278588 is not output | B |
A
B
for Power Tilt and Power Telescopic Steering Column:
for Manual Tilt and Manual Telescopic Steering Column: