The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the lower No. 1 instrument panel airbag assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
|
|
for 1GR-FE:
for V35A-FTS:
67914B 4.REMOVE FRONT DOOR SCUFF PLATE LH
62112 5.REMOVE COWL SIDE TRIM BOARD LH
55395C 9.REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH
73900 11.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
|
|
| *a | Turns off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Disconnect the airbag connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR
Remove the 4 bolts.
Disengage the claw to remove the lower No. 1 instrument panel airbag assembly.
77306 12.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
53601 13.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
14.REMOVE GROMMET