Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY (for Front Passenger Side) › 2021.04–2021.07
RM38G0E _58 Vehicle Interior _100751 SUPPLEMENTAL RESTRAINT SYSTEMS _0467881 KNEE AIRBAG ASSEMBLY(for Front Passenger Side) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(for Front Passenger Side)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
B664764N01
6.521,0.271 6.771,0.271 true 1.802,0.615 1.802,0.948 true 6.469,0.698 6.719,0.698 true 0.844,2.74 1.208,2.74 true 0.854,3.417 1.104,3.417 true 3.844,1.99 4.094,1.99 true 3.906,0.792 4.167,0.792 true 2.156,2.208 2.156,2.458 true 4.635,3.208 4.885,3.208 true 6.396,0.125 6.677,0.479 0.281,0.354 18 false 1 6.313,0.542 6.594,0.896 0.281,0.354 18 false 2 4.906,3.063 5.188,3.417 0.281,0.354 18 false 4 2.083,2.427 2.365,2.781 0.281,0.354 18 false 3 4.115,1.833 4.396,2.188 0.281,0.354 18 false 5 4.427,0.646 4.708,1 0.281,0.354 18 false 6 1.438,2.625 1.719,2.979 0.281,0.354 18 false 7 1.115,3.271 1.396,3.625 0.281,0.354 18 false 8 1.74,0.344 2.198,0.74 0.458,0.396 18 false 9 1.896,1.417 2.354,1.615 0.458,0.198 10 false x 3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL - (Click here) - -
3 NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 55607 - - -
4 FRONT DOOR SCUFF PLATE RH 67913B - - -
5 COWL SIDE TRIM BOARD RH 62111C - - -
6 NO. 1 INSTRUMENT SIDE PANEL 55317E (Click here) - -
7 LOWER NO. 2 INSTRUMENT PANEL PAD SUB-ASSEMBLY 55403H (Click here) - -
8 INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH 55394D - - -
9 LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY 73990 (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the lower No. 2 instrument panel airbag assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Multi-terrain monitor system (Click here)
Panoramic view monitor system (Click here)

HINT:
·

When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)
Lighting system (EXT) Cornering lights Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more. (Click here)
Pre-collision system
Lane tracing assist system
Lane departure alert system
Adaptive high beam system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor and expansion valve standard position is recognized. -


·

Use the same procedure for the LHD and RHD vehicles.

·

The procedure listed below is for the LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B475753

Be sure to read precaution thoroughly before servicing.

Click here(Click here)


NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





Hide 55607 3.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 67913B 4.REMOVE FRONT DOOR SCUFF PLATE RH

a.

Use the same procedure described for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL


Hide 62111C 5.REMOVE COWL SIDE TRIM BOARD RH

a.

Use the same procedure described for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL


Hide 55317E 6.REMOVE NO. 1 INSTRUMENT SIDE PANEL

Z101186

·

Use the same procedure described for the No. 2 instrument side panel.

Click here(Click here)



Hide 55403H 7.REMOVE LOWER NO. 2 INSTRUMENT PANEL PAD SUB-ASSEMBLY

Z101186

Click here(Click here)

Hide 55394D 8.REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER RH

a.

Use the same procedure described for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX (w/o Cool Box)>REMOVAL


Hide 73990 9.REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Z101186

CAUTION:
·
B528852N03
1.563,1.885 1.563,1.635 false 1.51,1.906 1.823,2.104 0.313,0.198 10 false *a

When storing the lower No. 2 instrument panel airbag assembly, keep the airbag deployment side (*a) facing upward.

·

If the airbag deploys for any reason, it may cause a serious accident.




a.
B608600C01
0.583,0.667 1.167,0.667 true 4.208,0.094 4.531,0.417 0.323,0.323 18 false ii 0.438,0.563 0.708,0.771 0.271,0.208 10 false *a 0.625,0.094 0.948,0.417 0.323,0.323 18 false i
*a Turns off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·

Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B608761N01
2.385,0.042 2.667,0.396 0.281,0.354 18 false i 0.583,2.104 0.865,2.458 0.281,0.354 18 false ii 4.042,2.115 4.323,2.469 0.281,0.354 18 false iii

i.

Disconnect the airbag connector.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



ii.

Remove the 3 bolts.


iii.

Disengage the claw and guide to remove the lower No. 2 instrument panel airbag assembly.