| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | BLOWER ASSEMBLY | 87130D | - | - | - |
| *A | w/ Cool Box | *B | w/o Cool Box |
| *C | for LHD | *D | for RHD |
| *1 | PIPING CLAMP | *2 | BRACKET |
| *3 | NO. 1 COOLER COVER | - | - |
| ● | Non-reusable part | - | - |
| *A | for 4 Zone Type | *B | for Dual Type |
| *1 | HEATER CASE (for Front Side) | *2 | HEATER CASE (for Rear Side) |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No. 1 cooler thermistor removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
When removing the air conditioning radiator damper servo sub-assembly, reinstallation is easier to perform if the following conditions are set before disconnecting the negative (-) battery terminal.
| Item | Condition |
|---|---|
| Air vent damper position | Face |
| Set temperature | Max cool |
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
87130D 1.REMOVE BLOWER ASSEMBLY
87128B 2.REMOVE NO. 2 HEATER GROMMET
88898D 3.REMOVE GROMMET
87201B 4.REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY (for RHD)
87124B 5.REMOVE HEATER CLAMP
87107A 6.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
88710A 7.REMOVE AIR CONDITIONING TUBE ASSEMBLY (w/ Cool Box)
88892N 8.REMOVE NO. 2 COOLER COVER (w/o Cool Box)
88515 10.REMOVE COOLER EXPANSION VALVE (w/o Cool Box)
87201B 11.REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY (for LHD)
82210K 12.DISCONNECT AIR CONDITIONING HARNESS ASSEMBLY
| *A | for 4 Zone Type | *B | for Dual Type |
87050D 13.REMOVE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
87050F 14.REMOVE NO. 4 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
88501 15.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
88625 16.REMOVE NO. 1 COOLER THERMISTOR