| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | RADIATOR SHUTTER ASSEMBLY | 53180E | - | - | - |
| 2 | UPPER RADIATOR SUPPORT SEAL | 53292A | - | - | - |
| 3 | COOLER THERMISTOR ASSEMBLY | - | - | - | - |
| 4 | COOLER THERMISTOR (AMBIENT TEMPERATURE SENSOR) | 88625P | - | - | - |
| *A | w/o Grille Shutter | *B | w/ Grille Shutter |
| *1 | COOLER THERMISTOR BRACKET | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ambient temperature sensor removal/installation are shown below.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
53180E 1.REMOVE RADIATOR SHUTTER ASSEMBLY (w/ Grille Shutter)
53292A 2.REMOVE UPPER RADIATOR SUPPORT SEAL (w/o Grille Shutter)
for Standard:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Standard)>REMOVAL
for Aero Type:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (for Aero Type)>REMOVAL
3.REMOVE COOLER THERMISTOR ASSEMBLY
| *A | w/o Grille Shutter | *B | w/ Grille Shutter |
88625P 4.REMOVE COOLER THERMISTOR (AMBIENT TEMPERATURE SENSOR)
| *1 | COOLER THERMISTOR BRACKET | - | - |