| *A | for Driver Side | *B | for Front Passenger Side |
| *C | w/ Courtesy Light | *D | w/ Cover |
| *E | w/ Reflex Reflector Assembly | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 10 | OUTER MIRROR CONTROL ECU ASSEMBLY LH | 89430A | ( ) |
- | - |
| 11 | OUTER MIRROR INSTALL HOLE COVER LH | 87964 | - | - | - |
| 12 | OUTER REAR VIEW MIRROR ASSEMBLY LH | 87940 | ( ) |
- | - |
| *A | w/ Reverse Shift-linked Mirror | - | - |
| *1 | GROMMET | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the outer rear view mirror assembly and side television camera assembly removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
2.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
3.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
67923E 8.REMOVE NO. 1 FRONT DOOR STIFFENER CUSHION
87964 11.REMOVE OUTER MIRROR INSTALL HOLE COVER LH
87940 12.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
w/ Reverse Shift-linked Mirror:
Detach the clamp.
Remove the 3 nuts.
Hold the outer rear view mirror assembly LH with one hand so that it does not drop.
Using a thin-bladed screwdriver, detach the claw and guide to remove the outer rear view mirror assembly LH.
Tape the thin-bladed screwdriver tip before use.
w/o Reverse Shift-linked Mirror:
Disconnect the connector and detach the clamp.
Remove the 3 nuts.
Hold the outer rear view mirror assembly LH with one hand so that it does not drop.
Using a thin-bladed screwdriver, detach the claw and guide to remove the outer rear view mirror assembly LH.
Tape the thin-bladed screwdriver tip before use.