| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | ROOF RACK ASSEMBLY | - | - | - | - |
| 2 | ROOF CARRIER SUB-ASSEMBLY LH | 63408C | - | - | - |
| 3 | ROOF RACK COVER | 63419A | ( ) |
- | - |
| 4 | NO. 2 ROOF DRIP SIDE FINISH MOULDING RETAINER | 75564B | - | - | - |
| *A | w/ Roof Rack | *B | w/ Roof Carrier |
| ● | Non-reusable part | ★ | Precoated part |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 5 | ROOF DRIP SIDE FINISH MOULDING JOINT COVER LH | 75597 | ( ) |
- | - |
| 6 | ROOF RACK BRACKET | 63185H | - | - | - |
| *A | w/ Roof Rack | *B | w/ Roof Carrier |
| *C | for Standard | - | - |
| ● | Non-reusable part | ★ | Precoated part |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 7 | ROOF HEADLINING ASSEMBLY | - | - | - | - |
| 8 | CURTAIN SHIELD AIRBAG ASSEMBLY LH | 62180A | - | - | - |
| *A | w/ Curtain Shield Airbag | *B | w/o Curtain Shield Airbag |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 9 | REAR ROOF RACK BRACKET | 63187A | - | - | - |
| *1 | INNER ROOF RACK RETAINER | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear roof rack bracket removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
1.REMOVE ROOF RACK ASSEMBLY (w/ Roof Rack)
63408C 2.REMOVE ROOF CARRIER SUB-ASSEMBLY LH (w/ Roof Carrier)
75564B 4.REMOVE NO. 2 ROOF DRIP SIDE FINISH MOULDING RETAINER (w/ Roof Carrier)
63185H 6.REMOVE ROOF RACK BRACKET
| *A | for Standard or w/ Roof Rack | *B | for Standard or w/ Roof Carrier |
| *C | for Standard | - | - |
7.REMOVE ROOF HEADLINING ASSEMBLY (w/o Curtain Shield Airbag)
62180A 8.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/ Curtain Shield Airbag)
63187A 9.REMOVE REAR ROOF RACK BRACKET
| *1 | INNER ROOF RACK RETAINER | - | - |
|
Remove in this Direction | - | - |