| *A | w/ Front Seat Side Airbag | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | - | - |
Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
72158F 1.INSTALL REAR INNER SEAT TRACK BRACKET COVER LH
72137Y 2.INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH
72123L 3.INSTALL FRONT INNER SEAT TRACK BRACKET COVER LH
72123M 4.INSTALL FRONT OUTER SEAT TRACK BRACKET COVER LH
5.INSTALL FRONT SEAT ASSEMBLY LH
Place the front seat assembly LH in the vehicle.
2 or more people are required when reinstalling the front seat assembly LH into the vehicle.
Protect the front seat leg.
Be careful not to damage the front seat assembly LH, body exterior or interior parts.
| *A | w/ Front Seat Side Airbag | - | - |
w/ Front Seat Side Airbag:
1. Connect the front seat airbag assembly LH connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector.
Connect the connector and attach the clamp under the front seat assembly LH to install the floor wire harness.
Insert the 2 location pins of the front seat assembly through the 2 body holes and place the front seat assembly.
Temporarily install the front seat assembly LH with the 4 "TORX" screws.
Operate the seat track adjusting handle LH and move the front seat assembly LH to the rearmost position.
Using a T50 "TORX" socket wrench, tighten the 2 "TORX" screws in the order shown in the illustration.
Operate the seat track adjusting handle LH and move the front seat assembly LH to the frontmost position.
Using a T50 "TORX" socket wrench, tighten the 2 "TORX" screws in the order shown in the illustration.
71910F 6.INSTALL FRONT SEAT HEADREST ASSEMBLY LH
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)
for 1GR-FE:
for V35A-FTS:
10. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART