| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | FRONT DISC | 43512 | ( ) |
- | - |
| 2 | DISC BRAKE CYLINDER ASSEMBLY | 47750 | - | - | - |
| 3 | FRONT FLEXIBLE HOSE | 47313J | ( ) |
- | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
|
Disc Brake Grease (Part No. 08887-80609) | - | - |
| *1 | FRONT DISC BRAKE ANTI-RATTLE SPRING | *2 | FRONT NO. 1 DISC BRAKE ANTI-SQUEAL SHIM |
| *3 | FRONT NO. 2 DISC BRAKE ANTI-SQUEAL SHIM | *4 | PIN HOLD CLIP |
| *5 | FRONT DISC BRAKE ANTI-RATTLE PIN WITH HOLE | *6 | FRONT DISC BRAKE PAD |
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the front disc brake pads, the brake pedal may feel soft due to clearance between the front disc brake pads and front disc. Depress the brake pedal several times until the brake pedal feels firm.
After replacing the front disc brake pads, always perform a road test to check the braking performance and check for vibrations.
When removing or installing the disc brake cylinder assembly, pushing back the disc brake piston may cause a large clearance between the brake pads and brake disc. When the brake pedal is depressed with a large clearance between the brake pads and the brake disc, DTC C13DB00, C13DC00, C13DD00, C13DE00, C140000 and/or C140A00 related to abnormal brake fluid pressure may be stored. Make sure to clear any DTCs after performing this procedure.
While the battery is connected, even if the ignition switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
43512 1.INSTALL FRONT DISC
| *a | Matchmark | - | - |
Align the matchmarks of the front disc and front axle hub sub-assembly, and install the front disc.
When replacing the front disc with a new one, select the installation position where the front disc has minimal runout.
47750 2.INSTALL DISC BRAKE CYLINDER ASSEMBLY
47313J 3.CONNECT FRONT FLEXIBLE HOSE
Connect the front flexible hose to the disc brake cylinder assembly with a new union bolt and a new gasket.
Install the front flexible hose lock securely into the lock hole in the disc brake cylinder assembly.
8.BLEED BRAKE LINE
9.INSTALL FRONT WHEEL
10. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART