| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | ENGINE OIL PRESSURE SWITCH ASSEMBLY | 83520 | ( ) |
- | - |
| 2 | INSPECT FOR OIL LEAK | - | ( ) |
- | - |
| 3 | INSPECT ENGINE OIL LEVEL | - | ( ) |
- | - |
| 4 | NO. 1 ENGINE UNDER COVER ASSEMBLY | 51410 | - | - | - |
| *1 | ENGINE SIDE COVER SUB-ASSEMBLY LH | *2 | ENGINE SIDE COVER SUB-ASSEMBLY RH |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
|
Adhesive 1344 |
| ★ | Precoated part | - | - |
83520 1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
Install the engine oil pressure switch assembly.
Do not start the engine within 1 hour of installation.
Connect the connector to the engine oil pressure switch assembly.
2.INSPECT FOR OIL LEAK
3.INSPECT ENGINE OIL LEVEL
51410 4.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY