37140 1.REMOVE FRONT PROPELLER SHAFT ASSEMBLY
2.DRAIN TRANSFER OIL
33309C 3.REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY (FRONT)
36111B 4.REMOVE TRANSFER CASE OIL SEAL
Using SST, remove the transfer case oil seal.
Apply grease to the tip of SST center bolt before use.
Be careful not to damage the transfer case oil seal and front transfer case contact surface.
36111B 5.INSTALL TRANSFER CASE OIL SEAL
Coat the lip of a new transfer case oil seal with MP grease.
Using SST and a hammer, tap in the transfer case oil seal.
Tap the transfer case oil seal evenly so that the transfer case oil seal is straight.
Tap in until there is no gap, as shown in the illustration.
33309C 6.INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY (FRONT)
7.ADD TRANSFER OIL
8.INSPECT FOR TRANSFER OIL LEAK
37140 9.INSTALL FRONT PROPELLER SHAFT ASSEMBLY