The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the floor side airbag sensor removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
|
|
for 1GR-FE:
for V35A-FTS:
67914B 3.REMOVE FRONT DOOR SCUFF PLATE LH
67918D 4.REMOVE REAR DOOR SCUFF PLATE LH
73233 5.REMOVE OUTER LAP BELT ANCHOR COVER
73220 6.REMOVE FRONT SEAT OUTER BELT ASSEMBLY LH (FLOOR ANCHOR)
62414A 7.REMOVE CENTER PILLAR LOWER GARNISH LH
89831E 8.REMOVE FLOOR SIDE AIRBAG SENSOR LH
| *a | Turns off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 60 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Disconnect the airbag connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR
Remove the bolt.
Loosen the bolt while holding the floor side airbag sensor LH because the floor side airbag sensor LH claw is easily damaged.
If the floor side airbag sensor LH has been dropped, replace it with a new one.
Disengage the claw to remove the floor side airbag sensor LH.