This DTC is stored when the blind spot monitor sensor LH (B) detects a short to ground in the outer rear view mirror indicator LH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C1AB411 | Outer Mirror Indicator (Module "B" Side) Circuit Short to Ground |
Both of the following conditions are met:
·
The blind spot monitor system is on
·
The current that is sent from the blind spot monitor sensor to the indicator is above a specified level for a specified period of time |
·
Outer mirror LH (outer rear view mirror indicator LH)
·
Outer mirror retractor LH
·
Harness or connector
·
Outer mirror control ECU assembly LH
·
Blind spot monitor sensor LH (B) |
Blind Spot Monitor "B" | A |
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Check for DTCs.
| Result | Proceed to |
|---|---|
| C1AB411 is not output | A |
| C1AB411 is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Pre-procedure1
Disconnect the T10 blind spot monitor sensor LH (B) connector.
Disconnect the N1 outer mirror control ECU assembly LH connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(T10)Location & Routingewd_type=routing;type=c;code=T10 Click Connector(T10)Body>No. 3 Floor Wire / Theft Warning Sensor Cord Sub-Assembly>Blind Spot Monitor Sensor LHewd_type=component;type=c;code=T10;pinno=4 |
||
| T10-4 (OMIL) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Pre-procedure1
Disconnect the z10 outer rear view mirror assembly LH connector.
Disconnect the B outer mirror LH (outer rear view mirror indicator LH) connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
Click Location & Routing(z10)Location & Routingewd_type=routing;type=c;code=z10 Click Connector(z10)Body>other>Outer Rear View Mirror Assembly LH , Outer Mirror Control ECU Assembly LHewd_type=component;type=c;code=z10;pinno=8 |
||
| z10-8 (BSM+) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Pre-procedure1
Disconnect the outer mirror control ECU assembly LH connector.
Procedure1
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 13 (BDSL) - 7 (GND) | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Click hereVehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR GLASS>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG