| *1 | VENTILATION HOSE | *2 | VACUUM HOSE |
| *3 | ENGINE SIDE COVER SUB-ASSEMBLY LH | *4 | ENGINE SIDE COVER SUB-ASSEMBLY RH |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 8 | AIR TUBE ASSEMBLY | 17360G | - | - | - |
| 9 | INTAKE AIR SURGE TANK | 17129 | - | - | - |
| *A | w/ Secondary Air Injection System | - | - |
| *1 | NO. 1 SURGE TANK STAY | *2 | NO. 2 SURGE TANK STAY |
| *3 | THROTTLE BODY BRACKET | *4 | NO. 1 VENTILATION HOSE |
| *5 | NO. 1 FUEL VAPOR FEED HOSE | *6 | NO. 4 WATER BY-PASS HOSE |
| *7 | NO. 5 WATER BY-PASS HOSE | - | - |
| ● | Non-reusable part | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.DISCHARGE FUEL SYSTEM PRESSURE
2. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
51410 4.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
51420 5.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
6.DRAIN ENGINE COOLANT
17880 7.REMOVE AIR CLEANER HOSE ASSEMBLY
17360G 8.REMOVE AIR TUBE ASSEMBLY (w/ Secondary Air Injection System)
17129 9.REMOVE INTAKE AIR SURGE TANK
25760 12.DISCONNECT VACUUM TRANSMITTING HOSE ASSEMBLY
23291 14.REMOVE INJECTOR VIBRATION INSULATOR
17111 15.REMOVE INTAKE MANIFOLD
Using an E7 "TORX" socket wrench, remove the 2 stud bolts from the intake manifold.
If a stud bolt is deformed or its threads are damaged, replace it.
Remove the 6 bolts, 4 nuts, intake manifold and 2 gaskets.