| *1 | NO. 1 AIR TUBE SUPPORT | *2 | ENGINE WIRE |
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
The necessary procedures(adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the generator assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3.REMOVE FRONT WHEEL
53782 4.REMOVE FRONT FENDER APRON TRIM PACKING A
5.DISCONNECT ENGINE WIRE
16711 6.REMOVE FAN SHROUD
7.REMOVE NO. 1 AIR TUBE ASSEMBLY
17341M 8.REMOVE NO. 1 AIR HOSE
16322 9.DISCONNECT WATER INLET PIPE
27060 10.REMOVE GENERATOR ASSEMBLY
|
Remove in this Direction | - | - |
Remove the 2 bolts and 2 nuts.
Using an E8 "TORX" socket wrench, remove the 2 stud bolts and generator assembly.
Remove the generator assembly as shown in the illustration.